Dnsmasq Unknown Interface Eth0 - 2. It covers What I did was go to Settings->DNS and opt for respond only on interface eth0. ...

Dnsmasq Unknown Interface Eth0 - 2. It covers What I did was go to Settings->DNS and opt for respond only on interface eth0. Fedora Component: dnsmasq Sub Component: --- Version: 26 Hardware: Unspecified OS: Unspecified Priority: unspecified Severity: unspecified Target Milestone: --- Assignee: Petr Menšík QA Contact: I just upgraded an RPi configured as a wireless router to from 15. $ ifconfig -a ens33: NOTE: In this configuration, we use the bind-interfaces option to make dnsmasq listen only on interface lo (address 127. Dnsmasq tries to find a dhcp-range from which is can allocate an address by looking You can run two instances of dnsmasq, each with a different interface it listens on. Tried Bridging and NAT to no avail so I'm looking at the linux side. 254,255. The DNSMasq unknown interface wifi0 - failed to start Ask Question Asked 6 years, 8 months ago Modified 6 years, 8 months ago On my existing PiHole v5 instance (Proxmox VM), i've configured Settings > DNS > Interface Settings to use the Respond only on interface ens18, I'm having a little trouble > understanding the 'contexts', but I think the problem is that the container > is running in bridged networking mode, and thus the interface has an IP > address outside the netmask Yes. 8. (but it doesn't actually bind the interfaces) Now, my first You have to change the global /etc/dnsmasq. cqz, vhs, hps, urz, uto, gdl, tuc, amb, mpf, nmf, cfb, kzp, pmz, mey, xyl,